Laser Service near Crawley on a Kent Laser 6090 – 80 watt – Hazelwick School
The visit to our new customer, Hazelwick School was requested as their Kent Laser machine was having a issue whereby the customer had reported that the laser would continue firing when the main lid was open. This laser service was conducted by our highly experienced service engineer ‘Gavin Edwards’. The visit included: –
Kent Laser 6090 – 130 watt
On arrival at Hazelwick School the machine was visually inspected. The customer who reported the issue had said that the machine continued to fire when the main enclosure door was opened.
The interlocks were inspected and two interlocks were found for the main lid, the interlocks were inspected and were found to be the magnetic reed switch. The right hand side interlock was found to be connected directly to the Ruida 6445 controller, the left hand interlock was found to be directly connected to the laser PSU.
The interlocks were tested as was all the sensors, and confirmed to be operating correctly. Due to the main lid being made out of Polycarbonate, it was a little bit flexible. So you could raise the door on the different sides to trigger the two main door interlocks separately. When raising the right hand side, the controller stopped the machine and showed a ‘Machine Protected’ error. When the left hand side was raised, the laser would stop firing, but the job would still be processing.

Having solved the issue the machine was given a service. The mirrors and main focusing lens were inspected and cleaned, the 2nd mirror was heavily contaminated. The main focusing lens had some small marks but should not effect cutting performance.
The following was carried out with no major issues seen: –
- Inspected and Cleaned Belts
- Inspect, Clean and Lubricate all Linear/Guide Rails
- Checked all Sensor and switches
- Electronics Inspection
- Safety Interlocks Inspection & Test
The laser unit was also connected to a Bofa fume extraction system. The filters were all checked are were functioning correctly and had been replaced recently. The external exhaust was also vented to atmosphere.


After all our standard service items were completed the laser power was measured from the laser nozzle. It was shown to measure 65w @99%.

Any of the consumable items mentioned above, Lens, Mirrors, Laser tubes, Power supplies are all available and can be bought separately in our online shop.
If you would like further information on our Laser Service near Crawley capabilities or anywhere else in the country, or any other Laser Repairing requirement or Laser Application, please request a call back or, talk to one of our service engineering specialists by going to our contact page – link below.
Contact Us for Laser Engraving, Marking & Cutting Advice (thinklaser.com)
Frequently Asked Questions:
How do I improve Inconsistent Cutting Depth?
Verify that the laser head is correctly focused for the material’s thickness
Check for debris or dust on the mirrors and lenses.
Ensure that the cutting bed is level across the entire work area.
How do I stop the laser from cutting unevenly?
Inspect and clean the optical components (mirrors and lenses).
Check that the work bed is level; an uneven bed will affect cutting depth.
Ensure the material is flat and secured in place on the bed.
How to stop the laser head dragging on Material
Ensure that the material is flat and not bowed or warped.
Check the height adjustment of the laser head and set the correct z-axis distance.
Verify that the workpiece is secured properly on the bed.
Does Thinklaser Service all Flatbed lasers
Short answer is Yes, we service a wide variety of flatbed laser models from the cheaper end of the market to the higher end the likes of Universal, Epilogue, GCC and more – Put us to the test!



