Laser Machine Service near Hassocks, on a 6040 60 watt HPC LaserScript Machine – Downlands Community School
A visit to a new customer, Downlands Community School was requested as the customer had said that the machine was in need of a service. The laser service was conducted by our highly experienced service engineer ‘Gavin Edwards’. The laser service visit included: –
Upon arrival at Downlands Community School the machine was visually inspected. The laser machine was found in a very dusty condition.
The laser chamber was completely hoovered out and whilst this was happening it was noted that the gas struts which hold the door open were weak and only just holding the lid open. This is a very point to note on all flatbed marking machines. The door to the enclosure is very heavy and if the gas struts are not of sufficient strength to hold the door open securely then there is a possibility that the door will close unexpectedly, possibly causing injury. This was noted to the customer has was advised that they be replaced as soon as possible.

The main focusing lens was inspected and found that the protective coating on the lens had been damaged. This was replaced with a new 2 inch lens.
The laser tube power was tested at the exit aperture of the nozzle. It was shown to be 30 watts at 100% requested power. This was discussed with the customer and an ex-demo 60W EFR Laser Tube. The laser power was tested again at the exit aperture of the nozzle and was shown to be 63.8 watts @ 75% requested power.

Whilst testing the laser at the exit aperture to the nozzle it was noticed that the red diode pointer was not working. This fault was traced to a break in the wiring within the cable chain. The wiring loom was replaced as was the red diode pointer due to heat damage on the wiring near the diode pointer.
The following were also checked as part of the visit
- Inspected, cleaned and oiled linear bearings
- Inspected Electronics Inspection
- Safety Interlocks Inspection & Test
- Inspected and tested all sensors
- Cleaned the extractor grill


Any of the consumable items mentioned above, Lens, Mirrors, Laser tubes, Power supplies are all available and can be bought separately in our online shop.
If you would like further information on our Laser machine service near Hassocks capabilities or anywhere else in the country, or any other Laser Training requirement or Laser Application, please request a call back or, talk to one of our service engineering specialists by going to our contact page – link below.


