Laser Machine Service near Bodmin on a Flux Hexa – National Grid Bodmin
A visit to a customer, National Grid -Bodmin Station was required as the customer had a Flux Hexa in need of a service. The service was conducted by our service engineer ‘Gavin Edwards’.
Flux Hexa
Upon arrival at National Grid -Bodmin Station the machine was visually inspected. The machine was visually in good condition with no obvious errors or issues with the machine. So the following service items were carried out: –
- Clean all Mirrors and Lens
- Inspect, Clean and Lubricate all Linear/Guide Rails
- Replaced cooling water
- Cleaned Exhaust Fan
- Clean Air Pump
- Clean Camera System
- Electronics Inspection
- Safety Interlocks Inspection & Test
Whilst checking the beam alignment it was found that the alignment was not properly aligned on the right hand side of the bed. This was then adjusted so that the beam was aligned to the centre of the aperture, in all four corners and the centre of the bed.


The laser power was checked at the nozzle and it was reading 32w @ 70% power. It was recommended that the tube be replaced, but the customer had said that they were going to be using some softer material for the next few months, so would keep the current laser tube for now.
The customer ran a number of test jobs and was happy with the service and the machine.
Any of the consumable items mentioned above, Lens, Mirrors, Laser tubes, Power supplies are all available and can be bought separately in our online shop.
If you would like further information on our Laser machine Service near Bodmin capabilities or anywhere else in the country, or any other Laser Training requirement or Laser Application, please request a call back or, talk to one of our service engineering specialists by going to our contact page – link below.


