Laser Machine Repair near Poole on a Techsoft Laser Cam 30 watt – Parkstone Grammar
The visit to our customer, Parkstone Grammar School was for an investigation/repair of their Techsoft Laser Cam flatbed marking machine. The customer was having issues with their extraction unit as well as the lens being marked, which they could not remove. This laser investigation/repair was conducted by our service engineer ‘Gavin Edwards’. The visit included: –
Techsoft Laser Cam – 30 Watt
On arrival the machine was visually inspected. We had been informed previously that the laser was not running at the normal speed and the extraction was slow to start.
The extraction unit was manually started and the unit took approximately 10 seconds to reach the required speed. Since on these units the extraction unit is turned on by the laser machine just as the job is started and turned off when the job finishes, it was advised to the customer that if they needed it to start sooner, then they would need to manually start the extraction unit. The reason for the extraction unit not performing as per expectation was the fact that the filters needed changing and the two issues in combination compounded the effects.

The engineer then moved onto the contaminated lens. All the turning mirrors were checked and cleaned. The contaminated lens was inspected and attempts were made to clean it. However the mark had been burnt onto the lens and was unable to be removed.


The laser power was tested at the exit to the nozzle. The power was reading 20w @100% power. The lens was removed and the powered tested again. This was then shown to be 31w @100%. Showing that the rest of the system was working as expected and it was the burn on the lens which was causing the drop off in power and the slower than normal processing speeds.


A second visit would not be required at Parkstone Grammar School, as the staff were confident about replacing the filters of the extraction unit and installing the new lens. The customer tested a number of their normal jobs and was happy with the repair.
Any of the consumable items mentioned above, Lens, Mirrors, Laser tubes, Power supplies are all available and can be bought separately in our online shop.
If you would like further information on our Laser Repair near Poole capabilities or anywhere else in the country, or any other Laser Repairing requirement or Laser Application, please request a call back or, talk to one of our service engineering specialists by going to our contact page – link below.
Contact Us for Laser Engraving, Marking & Cutting Advice (thinklaser.com)


