Best GCC Laser Service near Croydon

GCC Laser Service near Croydon, Mercury III 40 watts – Trinity School

A visit to a new customer, Trinity School. The customer had requested a service visit on their GCC Mercury III laser machine. The laser service was conducted by our highly experienced service engineer ‘Gavin Edwards’. The laser service visit included: –

GCC Mercury III 40 watt

Upon arrival at the Trinity School the flatbed machine was visually inspected. The machine was in generally good condition.

The mirrors and main focusing lens were inspected. The mirrors were cleaned, but the focusing lens was badly contaminated. However this was able to be cleaned. Before reinstating into the nozzle assembly the nozzle assembly was also cleaned.

The remaining items of a service were carried out with no issues: –

Inspect, Clean and Lubricate all Linear/Guide Rails
Deep Clean of system
Honey Comb Bed Inspection & Bed Leveling off by 1mm in the right corner
Electronics Inspection
Fan Filters cleaned
Inspected Laser Source, Cleaned Fans & Laser
Safety Interlocks Inspection & Test
Full Laser Alignment Check
Laser Tube Health Check

The customer was not using the Auto Focus pen, as they had had a number of broken units in the past few years and therefore didn’t wish to use the Auto Focus feature.

The beam alignment was tested and adjusted slightly. The laser power was measured at the exit aperture of the laser nozzle and was shown to be measuring 49.4w @100%. The customer was happy with the service provided.

Gcc Laser Service Near Croydon - Trinity School - Gcc Mercury Iii

Any of the consumable items mentioned above, Lens, Mirrors, Laser tubes, Power supplies are all available and can be bought separately in our online shop.

If you would like further information on our GCC Laser Service near Croydon capabilities or anywhere else in the country, or any other Laser Training requirement or Laser Application, please request a call back or, talk to one of our service engineering specialists by going to our contact page – link below.

Frequently Asked Questions:

How do I improve Inconsistent Cutting Depth?

Verify that the laser head is correctly focused for the material’s thickness
Check for debris or dust on the mirrors and lenses.
Ensure that the cutting bed is level across the entire work area.

How do I stop the laser from cutting unevenly?

Inspect and clean the optical components (mirrors and lenses).
Check that the work bed is level; an uneven bed will affect cutting depth.
Ensure the material is flat and secured in place on the bed.

How to stop the laser head dragging on Material

Ensure that the material is flat and not bowed or warped.
Check the height adjustment of the laser head and set the correct z-axis distance.
Verify that the workpiece is secured properly on the bed.