Machine type usedM Series laser marking system
Laser sourceNd:YAG Q Switched laser
ApplicationTechnical symbols
completion year2015
MaterialAluminium, Anodised black

As like with our customer HGL Dynamics, anodising has become a dominant form of finishing for aluminium. This is largely due to its cost effectiveness, availability and suitability, across a whole host of applications and industrial sectors. Laser marking anodised aluminium, has also become an accepted process across these industrial sectors.

Anodising is an electrolytic passivation process. It changes the microscopic texture of the aluminium by modifying the crystal structure near the surface. The passivation thickness will be between 10 and 25 microns, generally between 10 and 15 microns where colouring is used. This makes laser marking anodised aluminium very cost effective, as the layer can be removed easily and quickly. The laser is used to vaporise the top surface, removing the area affected by the anodising, exposing the aluminium material below. When a darker dye colouring is used, the contrast levels are very good.

Laser Marking Anodised Aluminium

Aluminium corrosion: The general consensus is, as the laser removes the anodised layer, an oxide layer forms on the surface providing protection.

CO2 lasers can also be used to process anodised aluminium. In this case, it is the dye that is directly affected rather than the material. The energy from the laser creates a heating action that removes the dye from the surface. The use of CO2 is generally not as well received as Nd:YAG or Fibre, due to the lower quality created by the mark process. This is directly related to the fact that the heating effect is difficult to control due to “heat creep”.  Subsequently, the per unit cost will be slightly higher with CO2 due to the process time being slower.

Various graphical symbols are imported into the control software used on the laser. Each symbol provides details about the sockets and plugs that will be fitted to the box during assembly. In this example, the symbols include power, network, headphones, and microphone. The unit is laser marked on 2 other sides with corporate branding as well.

If you would like further information on this application, or any other application, please request a call back or, talk to one of our laser marking specialists by going to our contact page – link below.

Contact Us for Laser Engraving, Marking & Cutting Advice (

Our Case Studies

Nike Foam Sheet Laser Engraved

Deep Laser Engraving of High Density Foam Tile
Laser Engraving Aluminium

Laser engraving Aluminium
Laser Engraving Gold Jewellery

Laser engraving gold jewellery