The component is a small filter housing used in the specialist applications and of high value. Due to the amount of information required on the part, the laser marking is combined with a rotary indexer to provide process capability. The rotary C drive is used to rotate the part to each position for laser marking.

A black mark is achieved by running the laser in CW mode where no material removal is the result. The rotary indexer is controlled by the laser marking software and rotates at each given position. It is not marking while rotating.

 

If you would like further information on this laser marking application, or any other application, please request a call back or talk to one of our laser marking specialists on 01737 826902

 

Our Case Studies

laser marking anodised aluminium

Laser marking Anodised Aluminium – Electrical symbols

Anodising has become a dominant form of finishing for aluminium. This is largely due to its cost effectiveness, availability and suitability, across a whole host of applications and industrial sectors. Laser marking anodised aluminium, has also become an accepted process across these industrial sectors.

Anodising is an electrolytic passivation process. It changes the microscopic texture of the aluminium by modifying the crystal structure near the surface. The passivation thickness will be between 10 and 25 microns, generally between 10 and…

VIEW CASE STUDY
laser marking anodised aluminium equipment front panel

Laser marking anodised aluminium – equipment front panels

Anodising has become a dominant form of finishing for aluminium. This is largely due to its cost effectiveness, availability and suitability, across a whole host of applications and industrial sectors. Laser marking anodised aluminium, has also become an accepted process across these industrial sectors.

Anodising is an electrolytic passivation process. It changes the microscopic texture of the aluminium by modifying the crystal structure near the surface. The passivation thickness will be between 10 and 25 microns, generally between 10 and…

VIEW CASE STUDY
product branding by laser marking anodised aluminium

Product branding by laser marking anodised Aluminium

A good example of product branding by laser marking is anodised aluminium. It is used in high end audio accessories in the form of cable tidies.  The aluminium is highly polished, prior to anodising, in order to achieve the high gloss finish on the part.

The laser process, delivers small pulses of energy to the component surface. These pulses have enough energy to vaporise the surface of the aluminium where the anodised coating occurs. This exposes the base material, aluminium,…

VIEW CASE STUDY